These are recommended setting for getting the optimum performance from your TinyTrack for normal APRS operations.
The settings were developed and tested over several weeks by experienced Operators to provide the best possible settings for Australian conditions. It is strongly recommended that you use them.
NORMAL VHF APRS OPERATIONS:
TinyTrack Version II VHF Configuration
Change the Callsign to your callsign using the -9 SSID.
You may need to change the Digi Path to RELAY,WIDE2-2 if you are more than 2 Digipeater hops from the nearest IGate.
TinyTrack Version 3 VHF Configuration
Change the Callsign to your callsign using the -9 SSID.
You may need to change the Digi Path to RELAY,WIDE2-2 if you are more than 2 Digipeater hops from the nearest IGate.
TinyTrack Version 3 HF Configuration
Change the Callsign to your callsign using the -15 SSID.
Notes:
Windows XP Issue
Some users have reported a problem using the
configuration software under Windows XP. The problem involves entries
in the config dialog that contain a single character or digit being changed or
reset to 0 when writing or changing between
Primary and Secondary configurations. If you experience this problem, the
work-around is to make sure no edit box entry
field contains a single char or number by entering characters twice in the
Symbol and Symbol Table fields (>> instead of
>), and add leading zeros in the numeric fields (03 instead of 3).
If you have problems configuring the TinyTrak3, try entering the follow DOS
command to configure the serial port:
mode COM1 PARITY=N DATA=8 STOP=1 OCTS=off
Development & Testing
The development and proving of these settings was done by a team lead by Tony VK5AH.
Thank you to Tony and his team for their efforts.